1 .Check whether the voltage complies with the local ones and whether there is a earth wire.
2. Turn off the power when changing the heating spare parts. Wear heat-proof glove when changing process is under high temperature.
3. Avoid long-time heating without media. If don’t cut off the power, put a special media to prevent it( waste media can do and can be used several times) Do not let he sharp part to make damages to the heating spare parts.
4. Avoid touching the heating part to prevent the burn.
5. Avoid the damage to human body caused by the spring.
6. If the pressure is too high when pressing downward, adjust the handle to move upward the head of the machine to lessen the compression degree of the spring.
7. When moving the head part upward and downward, must fix it tightly and relax the handle. You will the resistance when it reaches the downward extent. Then do not adjust again.
8. When fixing the head, the body is not fixed. No need to relax the handle too much. Stop when you feel the resistance.
9. Do not let the juveniles touch the machine even though it is not working.
1010. Put a aluminum board between the silica gel and metal board in small size when transferring for protection.
Tile:
Parameters: the starting temperature is 230 degree. The highest temperature is 330 degree. The heating time is 40 seconds.
Transferring: clean the surface of the tile, and stick the transfer paper to the upside surface. Fix it with the tile upward on the silica gel.
Press the handle and adjust the pressure according to the instruction above.
Metal board:
Parameters: the starting temperature is 230 degree. The highest temperature is 300 degree. The heating time is 40 seconds.
Transferring: take off the film of the metal board, and stick the transfer paper to the upside surface. Fix it with the tile upward on the silica gel.
Press the handle and adjust the pressure according to the instruction above.
Mug:
Parameters: Metal board: the starting temperature is 230 degree. The highest temperature is 330 degree. The heating time is 40 seconds.
Transferring: Put the mug into the mould.
Press the handle and adjust the pressure according to the instruction above.
Textile:
Parameters: the starting temperature is 355 degree. The highest temperature is 355 degree. Use the sublimation paper 30-50 seconds for the pure chemical fibers. Use T-shirt transfer paper 10-20 seconds for the pure cotton clothes)
Transferring: clean the surface of the tile, and stick the transfer paper to the upside surface. Fix it with the tile upward on the silica gel.
Press the handle and adjust the pressure according to the instruction above
Plate:
Parameters: the starting temperature is 230 degree. The highest temperature is 330 degree. Use the sublimation paper 30-50 seconds for the pure chemical fibers. Use T-shirt transfer paper 10-20 seconds for the pure cotton clothes)
Transferring: clean the surface of the tile, and stick the transfer paper to the upside surface. Fix it with the tile upward on the silica gel.
Press the handle and adjust the pressure according to the instruction above
Use the slow-transferring and turn off the machine each time the temperature rises 30 to 40 degree and turn it on 10 seconds later. By doing this, the percent of deformation plate can be reduced.
|
|
|
|
|
